RimShotz Accent reflective strips
for motorcycle and bicycle wheels and rims
Easy to install! No more 6 foot strips to entangle and get out of hand!
Our easy install method uses 23" interlocking sections that are much easier to handle.
RimShotz - Easy to Install
- Much easier to manage than ordinary tape
RimShotzWheel and Rim Effects provide badly needed side reflectivity for bicycles *non rim brake) and Motorcycles. RimShotz are installed in 23" sections (typically 3 per wheel per side) and feature our easy interlock butt edge design that assures perfect linking between sections and is virtually impossible to see the joints. Using our interlocking system ' is much easier than long 6 ft. strips of difficult to handle material, especially when working in the tight space of cycle wheels.
- Comes with shaping fluid and installation fluid
RimShotzcome pre formed in a curve, so they are already preconditioned to form the necessary smooth curve that you'll hand work into the actual shape of y our wheel. We use a highly durable adhesive that will bond to your rims and it will not come off until removed with solvents or a heat gun and scraper. Our adhesive is designed to work with a wet soap mixture that is provided which prevents bonding as you hand work the partially curved section into shape. once formed, you then rinse the strip and reapply with a mild solution (also provided) that gives brief adjustability to the replacement of the strip before it begins to bond. This 2nd solution is necessary to reposition and likely slightly reshape the section before allowing the strip to bond.
Once you complete installation of 1 23" section, then start on the next. Each section is interlocking so the joints are easy to align and nearly impossible to see once in place.
Once you complete the first section, then simply complete the next section by placing the RimShotz strip into place and interlocking it with the preformed butt end of the installed RimShotz . Repeat the procedure again for the third or final sections. Once the full loop is completed, simply lay the final section over the starting point, and slice through both sections with a razor blade and finish the loop by directly butt ending the loop with a sharp razor cut.
RimShotz come with two concentrated bottles of solution. A working solution and an installation solution. Just mix each of these in their own 32 ounce spray bottle and apply as needed.
Each RimShotz Kit comes with the following:
6 pcs of 23" long of interlocking - pre curved - rim reflector strips
1 - concentrated bottle of stop bonding solution (darker color solution)
1 - concentrated bottle of final installation fluid
1 - decal installation tool - flexible spatula
You can order additional strips if you wheels happen to be huge!
EMAIL US DO YOU HAVE A QUESTION ABOUT YOUR ORDER?
OUR DIRECT E-MAIL ADDRESS IS ON YOUR E-MAIL RECEIPT SENT TO YOU AT THE TIME OF YOUR ORDER. IF YOU DID NOT RECEIVE THIS RECEIPT, PLEASE CHECK YOUR SPAM FILTER.
Please note: Each wheel
takes 5 to 6 strips for both sides.